How to reset PASSWORD on SGI 300

[j***@get.com]

Unable to get past option 5 asking for PASSWORD. Is there a way to
reset the Password? Does this have something to do with the DALLAS
CHIP storing the Password! Is there a way you can reset it!

Thanks
Joeb



This is what I am seeing:
**** System Configuration and Diagnostics Summary ****
CONFIG:
No. of NODEs enabled = 1
No. of NODEs disabled = 0
No. of CPUs enabled = 2
No. of CPUs disabled = 0
Mem enabled = 1024 MB
Mem disabled = 0 MB
No. of RTRs enabled = 0
No. of RTRs disabled = 0

DIAG RESULTS:
NO DIAGS WERE RUN!
**** End System Configuration and Diagnostics Summary ****


System Maintenance Menu

1) Start System
2) Install System Software
3) Run Diagnostics
4) Recover System
5) Enter Command Monitor

Option? 5
Enter password:????????????????????????????????????? How do I get past
this point


System Maintenance Menu

1) Start System
2) Install System Software
3) Run Diagnostics
4) Recover System
5) Enter Command Monitor

Option?

[Marco Gariboldi]

Dear jbilinkiewicz,

There's a SGI repository/resource site, I believe it might've been
SGIstuff, where there was a 'how-to' of some sort to do this. I'd just
search for it on the Internet, as I don't recall exactly where I read it
either.



Kind regards,

Marco Gariboldi

Post by j***@get.com
Unable to get past option 5 asking for PASSWORD. Is there a way to
reset the Password? Does this have something to do with the DALLAS
CHIP storing the Password! Is there a way you can reset it!
Thanks
Joeb
**** System Configuration and Diagnostics Summary ****
No. of NODEs enabled = 1
No. of NODEs disabled = 0
No. of CPUs enabled = 2
No. of CPUs disabled = 0
Mem enabled = 1024 MB
Mem disabled = 0 MB
No. of RTRs enabled = 0
No. of RTRs disabled = 0
NO DIAGS WERE RUN!
**** End System Configuration and Diagnostics Summary ****
System Maintenance Menu
1) Start System
2) Install System Software
3) Run Diagnostics
4) Recover System
5) Enter Command Monitor
Option? 5
Enter password:????????????????????????????????????? How do I get past
this point
System Maintenance Menu
1) Start System
2) Install System Software
3) Run Diagnostics
4) Recover System
5) Enter Command Monitor
Option?